Local Panel Error Messages - Kodak DryView 8100 User Manual

DryView 8100 Laser Imager User Guide

Local Panel Error Messages

The following table lists the error messages displayed on the Local Panel. When an
error message is displayed, perform the operator action listed in the table for that
message. If this action does not clear the error message, call for service. When you
make a service call, be prepared to give the error message and message number to
the call taker (see page 5-18).
Note
In the table below the action "Cycle power" means to turn the imager Power
Switch off, wait 5 seconds, and then turn the switch on. If cycling power does
not clear the error, a service call is usually required.
Table 5-2. Local Panel Error Messages
Message Message
Number Displayed
P116 Pickup Fail
P118 Elevator Fail
P119 Feed Err Area 2 Film is stalled in the feed area.
P121 Printer Error
P123 Printer Error
P132 No Crtg
P133 Media Low
5-4
Message Details/
Operator Action
The film pickup arm is unable to pick up film from the
film cartridge. Try printing again. If the error recurs:
See Film Pickup Problems in Area 1 on page
5-11.
The cartridge elevator did not return to its home
position after the door was closed.
Cycle power.
See Removing film Jams from Area 2 on page
5-12.
The imager is unable to print due to system
problems.
Cycle power.
The imager is unable to print due to system
problems.
Cycle power.
There is no film cartridge in the imager.
Load a film cartridge.
Film cartridge contains less than 20 sheets.
Be ready to load a new film cartridge.
8754020 2000 March Rev. B