Kodak DryView 8100 User Manual page 56

Message Message
Number Displayed
P512 Calibrate Req
P513 Contrast Req
P514 Density Req
P515 Calibrate Fail
P542 Jam–Area 4
P543 Jam–Area 5
P544 Jam–Area 5
P550 Cleaning
Recmd
P551 Printer Error
P554 Printer Error
P561 Manual Mode
P601 Printer Error
through
P606
2000 March Rev. B 8754020
Message Details/
Operator Action
The user has requested a calibration test film or the
imager has initiated an automatic calibration test
film.
The user has requested a contrast test film.
The user has requested a density test print.
The calibration print failed. Request another
calibration.
If the error recurs, cycle power.
Film is stalled in the processor.
See Removing Film Jams from Area 4 on page
5-14.
Film is stalled between the processor and the
densitometer.
See Removing Film Jams from Area 5 on page
5-16.
Film is stalled between the densitometer and the exit
tray.
See Removing Film Jams from Area 5 on page
5-16.
The imager is due for cleaning. Schedule a service
call.
The imager is unable to print because the processor
heater did not warm up.
Note P number and call for service.
The imager is unable to print. The processor heater
is shut down because temperature was too high.
Cycle power.
The imager is operating in "manual" mode, without
Automatic Image Quality Control.
The imager is unable to print due to a system
problem.
Note P number and call for service.
Troubleshooting
5-7