Removing Film Jams From Area 5 - Kodak DryView 8100 User Manual

DryView 8100 Laser Imager User Guide

Removing Film Jams from Area 5

Area 5 consists of the components between the processor drum and the film exit
tray (see Figure 5-7). Jams can occur in this area between the drum and the
densitometer, or in the densitometer.
1. Open the upper hood.
!
Caution
Hot Surface
Drum and rollers inside the processor are hot. Exercise caution when working
in the drum area.
2. Clear the jammed film. (There may be more than one sheet.) If film is jammed in
the drive rollers (see Figure 5-7), use the green thumb tab to open the rollers and
free the film.
3. Close the upper hood.
Processor
Drum
Area 5
5-16
Exit Tray Pull green thumb tab in
direction shown to free
film jammed in rollers.
Figure 5-7. Jam Area 5
Densitometer
8100–55L
8754020 2000 March Rev. B