Table of Contents
Advertisement
DryView 8100 Laser Imager User Guide
Opening the Front Door Via the Local Panel
During normal machine operation, you will occasionally need to open the front door
(with power applied) to load and unload film cartridges, or to change the charcoal
filter. Also, if a film jam should occur in the lower part of the imager, you will need to
open the front door to clear the jam.
1. Press and release the Open Door key on the Local Panel (see Figure 3-3). The
imager will close the film cartridge, to avoid exposing film, and then unlatch the
door.
!
Caution
Do not leave the imager unattended when the front door is open.
2. A film jam can prevent the film cartridge from closing. When this occurs, the front
door will not open normally. In this case you can hold down the Open Door key
for 5 seconds to unlatch the door without closing the film cartridge. Several
sheets of film at the top of the cartridge will be exposed. You can minimize film
exposure by making the room as dark as possible.
Front Door
Figure 3-3. Opening the Front Door Via the Local Panel
3-6
Local Panel
Open Door Key
8754020
2000 March Rev. B
Advertisement
Table of Contents
