Kodak DryView 8100 User Manual page 54

Message Message
Number Displayed
P134 Crtg Empty
P137 Open Door Req
P138 Press Open 5S
(This message
alternates with
P177.)
P139 Bad Barcode
P145 Media Type Err
P146 Media Size Err
P149 Wait FilmModel
P154 Disk Maint
2000 March Rev. B 8754020
Message Details/
Operator Action
The film cartridge is empty.
Insert a new film cartridge.
The front door will not open because the imager is
printing.
Wait until S25 (cartridge closing) is displayed.
The front door does not unlatch because the film
cartridge would not close or the elevator would not
lower.
Hold down the Open Door key on the Local Panel
for 5 seconds to force the front door open. Clear the
film jam or other error condition and manually close
the film cartridge. The top few sheets in the film
cartridge will be exposed.
The imager is unable to read the barcode on the
bottom of the film cartridge.
Try a different film cartridge.
A reading of the barcode on the cartridge indicates
that the cartridge contains the wrong type of film.
Replace the cartridge with one containing the correct
type of film.
A reading of the barcode on the cartridge indicates
that the cartridge contains film of the wrong size.
Replace the cartridge with one containing the correct
size film.
The system is calculating film descriptive data from
the barcode data on the film cartridge.
Wait until the calculation is complete.
The system is operating normally. A file system
problem is being corrected by recovery from a recent
backup. DO NOT cycle power while this message is
displayed. If power is cycled, the recovery will have
to start over from the beginning.
Troubleshooting
5-5