Figure 5-3 Display Modes; Figure 5-4 Mode Examples - Emerson MP25A4 User Manual

Safety Product Mechanical
Information information Installation

Figure 5-3 Display modes

Status
Mode
(Display
not
flashing)
To enter Parameter
Mode, press
Parameter
Mode
(Upper
display
flashing)
Use
* keys
to select parameter for editing
To enter Edit Mode,
press key
RO R/W
parameter parameter
* Can only be used to move between menus if L2 access has been enabled Pr 11.44 (SE14, 0.35)
**Time-out defined by Pr 11.41 (default value = 240s).

Figure 5-4 Mode examples

Parameter
View Mode
Menu 5. Parameter 5
Pr 5.05 value
Do not change parameter values without careful
consideration; incorrect values may cause damage or a
safety hazard.
WARNING
NOTE
When changing the values of parameters, make a note of the new
values in case they need to be entered again.
NOTE
For new parameter-values to apply after the AC supply to the drive is
interrupted, new values must be saved (section 5.8 Saving
parameters on page 61).
Mentor MP User Guide
Issue: 3
Electrical Getting Basic
installation started parameters
Timeout**
key or
To return to
Status Mode,
press
When returning
to Parameter
Mode use the
*
keys to select
another parameter
to change, if
required
To exit Edit Mode,
press
Edit Mode
(Character to be edited in lower line of display flashing)
Change parameter values using
Healthy Status
www.controltechniques.com
Running the SMARTCARD
Optimization
motor operation
Timeout** Timeout**
key
Temporary
Parameter
Mode
(Upper display
flashing)
key
keys.
Status Mode
Alarm Status
Onboard Advanced Technical
Diagnostics
PLC parameters data
Trip Status
Drive status = tripped
Trip type (UV = undervolts)
UL
information
57