Airflow Direction Control - Electrolux Kelvinator KSV Series User Manual

USING THE REMOTE CONTROLLER

Airflow direction control

Range
Vertical
louvre
Range
AUTO
CLOCK SET TEMP.
C
FAN SPEED
FAN
SWING
TIMER
SLEEP CLOCK CANCEL
SPARE
LED
AIM
Up and down air flow
Left and right air flow
Adjust the air flow direction properly, otherwise it might
cause discomfort or cause uneven room temperatures.
Adjust the horizontal louvres by using the remote controller.
Adjust the vertical louvres manually.
To set the up--down air flow direction
Perform this function while the unit is in operation.
Press the AIM button on the remote controller to move the
louver to the desired direction.
The readjusting angle of the horizontal louvre is 6 for each
press.
To set the left--right air flow direction (manually)
Perform these adjustments before you start the unit
because once it has been started, on the fan there is
a risk of your fingers getting caught on the fan.
To set the automatically up and down air flow direction
Perform this function while the air conditioner is in operation.
Press the SWING button on the remote controller, the
horizontal louver will swing up and down automatically.
To stop the function, press the SWING button
again.
CAUTION
!
The SWING & FIX buttons will be disabled when the air conditioner
is not in operation(including when the TIMER
Do not operate the air conditioner for long periods
direction set downward in cooling or dry mode. Otherwise,
may occur on the surface of the horizontal louvre causing moisture to
drop on to the floor or on furnishings.
Do not move the horizontal
FIX button. If you move this
operation. If the louvre malfunctions, stop the air conditioner once and
restart it.
When the air conditioner is started immediately after it was stopped,
the horizontal louvre may not move for approximately 10 seconds.
Open angle of the horizontal
COOLING or HEATING performance may be impaired due to too
restricted air flow area.
Do not operate unit with horizontal
When the air conditioner is connected to power (initial operation), the
horizontal louvre may generate a sound for 10 seconds, this is
a normal operation.
20
ON is set).
with the air flow
louvre manually. Always use the
louvre manually, it may malfunction during
louvre should not be set too small, as
louvre in closed position.
O
condensation
SWING &