Table of Contents
Advertisement
Voltage Measurement Cable and Current Probe Connections
Overview
Introduction
In this chapter
WARNING
Shop for Power Metering products online at:
C H A P T E R
This section describes how to connect the Energy Platform to make basic single phase
voltage measurements. For multi-phase connection diagrams, refer to Appendix E.
The following topics are covered in this c
Connecting Voltage Measurement Cables
Connecting Current Probes
Death, serious injury, or fire hazard could result from improper connection of this
instrument. Read and understand this manual before connecting this instrument.
Follow all installation and operating instructions while using this instrument.
Connection of this instrument must be performed in compliance with the National
Electrical Code (ANSI/NFPA 70-2008) and any additional safety requirements
applicable to your installation.
Installation, operation, and maintenance of this instrument must be performed by
qualified personnel only. The National Electrical Code defines a qualified person
as "one who has the skills and knowledge related to the construction and
operation of the electrical equipment and installations, and who has received
safety training on the hazards involved."
Qualified personnel who work on or near exposed energized electrical conductors
must follow applicable safety related work practices and procedures including
appropriate personal protective equipment in compliance with the Standard for
Electrical Safety Requirements for Employee Workplaces (ANSI/NFPA 70E-2009)
of USA and any additional workplace safety requirements applicable to your
installation.
PowerMeterStore
www.
2
hapter.
Topic
See Page
2-4
2-9
Continued on next page
2-1
1.800.561.8187
.ca
Advertisement
Table of Contents
