Table of Contents
Advertisement
Battery Pack Replacement
Battery Pack Replacement
Introduction
WARNING
ADVERTENCIA Reemplace con batería Dranetz NiMH BP-PX5 solamente.
AVERTISSEMENT Remplacer par la batterie Dranetz NiMH BP-PX5 exclusivement.
WARNUNG
NOTE
Procedure
C-4
Shop for Power Metering products online at:
The Energy Platform contains an easily replaceable internal battery pack. See
Appendix D for ordering information.
Replace with Dranetz NiMH battery pack BP-PX5 only.
Nur mit Dranetz NiMH BP-PX5 Batteriesatz auswechseln.
During normal operation, the battery pack will be slightly warm to the touch.
Follow these steps to replace the battery pack.
Step
1
Press the Energy Platform power button to off.
2
Turn off power to the circuit being measured.
3
Disconnect voltage and current probes from the circuit and the Energy
Platform's rear panel.
4
On the bottom of the Energy Platform, push the tab to release the battery
cover. Refer to the diagram shown on page C-5.
5
Remove the cover.
6
Pull up on removal strap and remove battery pack.
7
Insert the new pack into the compartment making sure to observe
polarity markings.
8
Replace the cover and press down until it latches closed.
9
Discard the old battery pack in accordance with Environmental
Protection Agency (EPA) regulations.
10
Press the Energy Platform power button to on.
PowerMeterStore
www.
Action
Continued on next page
.ca
1.800.561.8187
Advertisement
Table of Contents
