Set Outband Speed; Set Policy Type - Avaya C460 Reference Manual

The syntax for this command is:
set outband negotiation {enable | disable}
enable
disable
Example:
C460-1# set outband negotiation enable
Auto-negotiation for outband port set successfully

set outband speed

User level: read-write, admin.
Use the set outband speed command to configure the speed of Ethernet
Console port.
In auto negotiation mode, the port's speed is determined by auto negotiation. If you
attempt to set the speed when auto negotiation is enabled, the following message is
displayed "Auto negotiation is Enable, can not set the speed
mode."
The syntax for this command is:
set outband speed <speed>
speed
Example:
C460-1# set outband speed 100MB
Speed for outband port set successfully

set policy type

User level: read-write, admin.
Use the set policy type command to set whether the C460 switch enforces the
active policy-list on all packets or only on routed packets (in "device-mode router").
Avaya C460 Reference Guide
Enable link negotiation protocol.
Disable link negotiation protocol.
• 10MB
• 100MB
Chapter 2 Avaya C460 CLI Commands
97