Table of Contents
Advertisement
Chapter 2
Avaya C460 CLI Commands
set interface ppp {enable|enable-always|disable|off|reset}
enable
enable-always
disable
off
reset
Example:
C460-1# set interface ppp reset
PPP has reset the connected modem.
Example:
C460-1# set interface ppp enable
Entering the Modem mode within 60 seconds...
Please check that the proprietary modem cable is plugged
into the console port
Example:
C460-1# set interface ppp disable
Entering the Terminal mode immediately
set ip route
User level: read-write, admin.
Use the set ip route command to adds a route to the IP routing table. You can
configure from 1 to 10 default static gateways for a C460 switch.
The syntax for this command is:
set ip route <destination> <netmask> <gateway>
destination
netmask
gateway
92
Enable PPP and enter modem mode.
Enter modem mode every time that the proprietary modem
cable is plugged into the console port.
Disable PPP and enter terminal mode
Disconnect the active PPP session.
Reset the connected modem.
IP address of the network, or specific host to be added
Subnet mask
IP address of the router
Avaya C460 Reference Guide
Advertisement
Table of Contents
