Table of Contents
Advertisement
ping
User level: read-only, read-write, admin.
Use the ping command to send ICMP echo request packets to another node on the
network.
The syntax for this command is:
ping [host]
host
Example: to ping the IP number 149.49.48.1:
C460-1> ping 149.49.48.1
149.49.48.1 is alive
ping (Layer 3)
User level: user, privileged, supervisor
Use the ping command to send ICMP echo request packets to another node on the
network.
The syntax for this command is:
ping <host> [<interval> [<size> [<timeout> [<source
address>]]]]]
host
interval
size
timeout
source
address
Avaya C460 Reference Guide
Host IP address/Internet address of route destination.
If you do not specify a host IP, then the last host IP is used.
Host IP address/Internet address of route destination. If missing
then the last host IP is used.
Interval between ping commands in seconds (1 to 256)
Size of packet in bytes (22 to 66500)
Timeout in seconds (1 to 10)
IP address of one of the router interfaces
Chapter 2
Avaya C460 CLI Commands
71
Advertisement
Table of Contents
