Table of Contents
Advertisement
Chapter 2
Avaya C460 CLI Commands
otherwise you will get an error message.
When adding a port to an existing LAG, type the same LAG name, otherwise
you will create a new LAG.
The syntax for this command is:
set port channel <port_list> {value} [name]
port_list
value
name
(Optional)
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".
Example:
C460-1#
Port 4/6 channel mode set to on
Port 4/18 was added to channel
set port classification
User level: read-write, admin.
Use the set port classification command to set the port classification to
either regular or valuable. Any change in the Spanning Tree state from Forwarding
for a valuable port will erase all learnt MAC addresses in the switch.
The syntax for this command is:
set port classification [module/port]
module port
regular | valuable
Example:
C460-1# set port classification 2/19 valuable
Port 2/19 classification has been changed.
100
A list of ports to be aggregated in the format module/port
• on – enable a channel for the specified module port
• off – disable a channel for the specified module port
channel name
set port channel 4/6,18 on server2
module/port range
port classification
{regular | valuable}
Avaya C460 Reference Guide
Advertisement
Table of Contents
