Table of Contents
Advertisement
Chapter 2
Avaya C460 CLI Commands
seconds
Example:
C460-1(super)# set port dot1x quiet-period 1/2 5000
set port duplex
User level: read-write, admin.
Use the set port duplex command to configure the duplex type of an Ethernet
or Fast Ethernet port or range of ports.You can configure Ethernet and Fast Ethernet
interfaces to either full duplex or half duplex.
The duplex status of a port in auto-negotiation mode is determined by auto-
negotiation. An error message is generated if you attempt to set the transmission
type of auto negotiation Fast Ethernet ports to half- or full-duplex mode.
The syntax for this command is:
set port duplex <module>/<port> [value]
module
port
value
Example:
To set port 1 on module 4 to full duplex:
C460-1# set port duplex 4/1 full
Port 4/1 set to full-duplex.
set port edge admin state
User level: read-write, admin.
Use the set port edge admin state command to set the port as an RSTP
edge-port or non-edge-port.
106
Time interval in seconds — 0-65535
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
• full – set full-duplex transmission
• half – set half-duplex transmission
Avaya C460 Reference Guide
Advertisement
Table of Contents
