Table of Contents
Advertisement
Example:
C460-1# set port mirror source-port 3/9 mirror-port 4/10
direction both
Mirroring both Rx and Tx packets from port 3/9 to port 4/10
is enabled
set port name
User level: read-write, admin.
Use the set port name command to configure a name for a port. If you do not
specify a name, the port name remains blank.
The syntax for this command is:
set port name <module>/<port> [value]
module
port
value
Example:
C460-1# set port name 4/21 arthur
Port 4/21 name set.
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".
set port negotiation
User level: read-write, admin.
Use the set port negotiation command to enable or disable the link
negotiation protocol on the specified port. This command applies to Fast Ethernet or
Gigabit Ethernet ports.
When negotiation is enabled, the speed and duplex of the Fast Ethernet ports are
determined by auto-negotiation.
If negotiation is disabled, the user can set the speed and duplex of the Fast Ethernet
Avaya C460 Reference Guide
Number of the module (3-6).
Number of the port on the module. If you do not specify a
number, the same name is set for all the ports on the module.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
Name (up to 16 characters)
Chapter 2
Avaya C460 CLI Commands
111
Advertisement
Table of Contents
