Table of Contents
Advertisement
MAINTENANCE & TROUBLESHOOTING
WARNING: To prevent electrical shock, turn off and unplug the treadmill before cleaning or
performing routine maintenance.
Remove everything on the table before adjusting the table to different angle. Ensure the knob is
secured before placing anything on the table.
CLEANING
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or solvents.
Be careful not get excessive moisture on the display panel as this might cause an electrical hazard
or electronics to fail.
Please keep the treadmill, especially, the console, out of direct sunlight to prevent screen damage.
TROUBLESHOOTING GUIDE
Problem
Treadmill will not
start.
Belt slips.
Belt hesitates
When stepped on.
Belt is off centered.
Potential Causes
1.
Not plugged in.
2.
Safety tether key not
connected.
3.
House circuit breaker
tripped.
4.
Treadmill circuit breaker
tripped.
1. Belt not tight enough.
1.
Not enough lubrication
applied onto the running
deck.
2.
Belt is too tight.
1. Walking belt tension is not
even across the rear roller.
1.
Put the power plug into the
electrical wall outlet.
2.
Install the safety tether key.
3.
Reset or have an electrician
replace the breaker in home.
4.
Wait five minutes and then press
the switch back on.
1. Adjust belt tension.
1.
Apply silicone lubricant.
2.
Adjust the belt tension.
1. Center the belt.
26
Corrections
Hide quick links:
Advertisement
Table of Contents
