Table of Contents
Advertisement
ASSEMBLY
Tool:
5mm Allen Wrench with
Phillips Screwdriver
1. Installing the Handlebar Support Tube Frame
As you are installing the Handlebar Support Tube Frame (75), connect the Sensor Cable II (30)
from the inside of the Handlebar Support Tube Frame (75) to the Sensor Cable I (29) which is
inside the right side of the Stabilizer (57). Slide the Handlebar Support Tube Frame (75) into the
Stabilizer (57) and align the bolt holes. Secure the frame in place with six Bolts (32) and six
Spring Washers (73). Tighten the Bolts (32) with the 5mm Allen Wrench with Phillips
Screwdriver provided.
IMPORTANT: While sliding the Handlebar Support Tube Frame (75) into the Stabilizer (57),
make sure the cables are installed INSIDE the tube and ensure that you do not pinch the wires.
Hardware:
(32) Bolt
(73) Spring Washer
6 PCS
6 PCS
12
Hide quick links:
Advertisement
Table of Contents
