Table of Contents
Advertisement
Tool:
5mm Allen Wrench with
Phillips Screwdriver
1pc
4. Installing the Right Side Handlebar, Speed and Hand Pulse Sensors
Connect the Speed Buttons and Hand Pulse Sensor with Wires (63) from the Right Handlebar
(85R) to the Pulse Extension Wire (100) and Control Button Extension Wire (101) from the right
side of the Handlebar Support Tube Frame (75). Then connect the Right Handlebar (85R) to the
right side of the Handlebar Support Tube Frame (75) using two Bolts (32), two Spring Washers
(73), and two Curve Washers (102). Tighten the bolts with the 5mm Allen Wrench with Phillips
Screwdriver provided.
5. Installing the Left Side Handlebar, Incline and Handle Pulse Sensors
Connect the Incline Buttons and Hand Pulse Sensor with Wires (62) from the Left Handlebar
(85L) to the Pulse Extension Wire (100) and Control Button Extension Wire (101) from the left
side of the Handlebar Support Tube Frame (75). Then connect the Left Handlebar (85L) to the
left side of the Handlebar Support Tube Frame (75) with two Bolts (32), two Spring Washers
(73), and two Curve Washers (102). Tighten the bolts with the 5mm Allen Wrench with Phillips
Screwdriver provided.
IMPORTANT: While sliding both Right/Left Handlebars (85R/85L) onto the Handlebar Support
Tube Frame (75), make sure the wires are installed inside the tubes and take care not to pinch the
wires.
Hardware:
(32) Bolt
ASSEMBLY
(73) Spring Washer
4 PCS
(102) Curve Washer
4PCS
15
4PCS
Hide quick links:
Advertisement
Table of Contents
