Exerpeutic Workfit 1030 Owner's Manual page 30

Problem
Er 5 (Excessive
drive motor
current.)
Er 6 (The motor
can not work.)
Er 7 (PCB did
not receive any
signal.)
SAFE (Safety key
is loose or
unplugged.)
MAINTENANCE & TROUBLESHOOTING
Potential Causes
1. Check your machine to make
sure the running belt is without
any abnormal interference.
1. Check if the wire that connects
to the motor is connected
properly or not.
1. Bad communication for upper
and lower controller.
2. The communicate signal from
upper or lower controller is bad
by interference from motor.
Check the position of the safety key.
1. Turn off the Power Switch
to the OFF position, wait 30
seconds, then turn on the
Power Switch to the ON position. If
the screen still shows Er 5,
please notify your local Customer
Service Center.
1. Reconnect the wire or turn off the
Power Switch to the OFF
position, wait 30 seconds, then
turn on the Power Switch
to the ON position. If the screen
still shows Er 6, please notify your
local Customer Service Center.
1. Check the cables are in good
connection.
2. Turn off the Power
Switch to the OFF position,
wait 30 seconds, then turn on
the Power Switch to
the ON position. If the screen
still shows Er 7, please notify
your local Customer Service
Center.
Replace the Safety Key.
28
Corrections