Care, Maintenance & Trouble Shooting Guide; Belt; Running Belt; Running Deck - Exerpeutic 97670 Owner's Manual

14
CARE, MAINTENANCE &
TROUBLE SHOOTING GUIDE
WARNING: To prevent electrical shock, please turn off and unplugged the treadmill before cleaning or routine maintenance.
CLEANING
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or solvents. Be careful not to get excessive
moisture on the display panel as this might cause a electrical hazard or the electronics to fail.
Please keep the equipment, especially the console, out of direct sunlight to prevent screen damage.
STORAGE
Store the treadmill in a clean and dry environment. Ensure the master power switch is off and is at the off position and the power
plug is un-plugged from the electrical wall outlet.
TROUBLE SHOOTING GUIDE
Problem
Treadmill will not start.
Running belt slips.
Running belt hesitates
when stepped on.
Running belt is off centered.
Potential Cause
1. Not plugged in.
2. Safety tether key not installed.
3. House circuit breaker tripped.
4. Treadmill circuit breaker tripped
ON/OFF switch on OFF.
1. Running belt not tight enough.
2. Drive belt not tight enough.
1. Not enough lubrication applied
onto the running deck.
2. Running belt too tight.
Running belt tension not even across
the rear roller.
Corrections
1. Plug into grounded outlet.
2. Install safety tether key onto the monitor.
3. Reset or replace fuse.
4. Lubricate treadmill deck and reset.
5. Turn ON/Off switch to ON.
1. Adjust running belt tension.
2. Adjust drive belt tension.
1. Apply silicone lubricant.
2. Adjust running belt tension.
Center the running belt.