Trouble Shooting & Maintenance - Exerpeutic 1000 Owner's Manual

TROUBLE SHOOTING & MAINTENCE
TROUBLE SHOOTING
PROBLEM: Treadmill running belt slips or is not centered on rear roller.
SOLUTION: Refer to "Adjusting the Running Belt" section on page 14.
PROBLEM: Computer not working correctly
SOLUTION: Check to make sure the computer wires are connected securely.
SOLUTION: Check the batteries are correctly positioned and battery springs are
proper contact with batteries.
SOLUTION: Make sure the batteries are not dead.
PROBLEM: There is no heart rate reading or heart rate reading or is erratic /
inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are
secure.
SOLUTION: To ensure the pulse readout is more precise, please always hold on
to the handlebar grip sensors with two hands instead of just with one hand only
when you try to test your heart rate figures.
SOLUTION: Gripping the hand pulse sensors too tight. Try to maintain
moderate pressure while holding onto the hand pulse sensors.
PROBLEM: The magnetic treadmill makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the magnetic treadmill, please inspect the
bolts and tighten the loose ones.
MAINTENANCE
Cleaning
The magnetic treadmill can be cleaned with a soft cloth and mild detergent. Do
not use abrasives or solvents on plastic parts. Please wipe your perspiration off
the magnetic treadmill after each use. Be careful not get excessive moisture on
the computer display panel as this might cause an electrical hazard or electronics
to fail. Please keep the magnetic treadmill, specially, the computer console, out
of direct sunlight to prevent screen damage. Please inspect all assembly bolts
on the machine for proper tightness every week.
Storage
Store the magnetic treadmill in a clean and dry environment away from children.
16