ASSEMBLY
Step 1
Connect the Sensor Cable I (29) from inside the Stabilizer (57) to the Sensor
Cable II (30) from inside the right side of the Handlebar Support Tube Frame
(75). Then connect the Handlebar Support Tube Frame (75) to the Stabilizer
(57) by inserting the Handlebar Support Tube Frame (75) onto the Stabilizer (57),
using six M8x16mm Bolts (32) and six M8 Spring Washers (73). Tighten bolts
with the 5M Allen Wrench with Phillips Screwdriver provided.
IMPORTANT: While sliding the Handlebar Support Tube Frame (75) onto the
Stabilizer (57), make sure the cables are installed inside the tube and pay
attention not to pinch the cables.
75
73
32
73
32
30
29
57
Tool:
Hardware:
Allen Wrench with
(32) Bolt (M8x16mm)
(73) Spring Washer (M8)
Phillips Screwdriver 5M
6 PCS
6 PCS
12