Assembly Instructions - Exerpeutic 97670 Owner's Manual

8
ASSEMBLY INSTRUCTIONS
Step A:
Turn the Spring Knob (23) in a counterclockwise direction and then pull it to set down the Main Frame (1)
on the floor. Turn the Spring Knob (23) clockwise to secure the treadmill in the folding down position.
First remove four Stabilizer Knobs (32) and Washers (74) from the right and left sides of Stabilizer (57).
Then insert the both Stabilizer Tubes (30) into the tubes of Stabilizer (57) and secure them with four
Stabilizer Knobs (32) and Washers (74) that were removed.
Step B:
Pull the Short Knob (63), and then lift the Handlebar (68) all the way up. Tighten the Handlebar (68) to the
Stabilizer (57) with two Handlebar Knobs (67) and Washers (73).
Step C:
Connect the Mode Button Wire (64), Speed Button Wire (62), and Sensor Cable (33) to the wires that
come from the Computer (70). Attach the Computer (70) onto the Handlebar (68) with two Computer Knobs (69).
Install the Safety Tether Key (65) onto the Computer (70).
Step D:
There are five Adjustable Pads (28) on the bottom of both Stabilizer Tubes (30) and Stabilizer (57). You can adjust
the Adjustable Pad (28), if the floor is not level.
1
C
68
A
32
74
57
30
23
70
69
64
62 69
65
33
B
68
67
73
63
D
30
28
67
73
57
28
28
57