GE B30 Instruction Manual page 152

5.2 PRODUCT SETUP
The fixed GOOSE settings are shown below:

PATH: SETTINGS PRODUCT...
 FIXED GOOSE

These settings are applicable to fixed (DNA/UserSt) GOOSE only.
The setting represents the IEC 61850 GOOSE application ID (GoID) name string sent as part of each GOOSE
GOOSE ID
message. This string identifies the GOOSE message to the receiving device. In revisions previous to 5.0x, this name string
was represented by the
The
DESTINATION MAC
address; the least significant bit of the first byte must be set. In B30 releases previous to 5.0x, the destination Ethernet
5
MAC address was determined automatically by taking the sending MAC address (that is, the unique, local MAC address of
the B30) and setting the multicast bit.
The
GOOSE VLAN PRIORITY
have higher priority than other Ethernet data. The
ID for each GOOSE sending device. This value can be left at its default if the feature is not required. Both the
and
PRIORITY GOOSE ETYPE APPID
Firmware version 5.83 introduces dynamic
5.8x, starting with 5.83. Dynamic VLAN priority allows changing the priority of retransmitted GOOSE messages. The first
GOOSE message triggered on a state change has the highest priority and each subsequent re-transmitted GOOSE mes-
sage follows the pre-defined priority level according to the following
GOOSE re-transmission (based on the retransmission profile setting) has a priority that is decremented by one count. This
repeats until the actual priority value reaches the "end" of the dynamic priority range. For Instance, a VLAN priority setting
of 7 sets the priority of the first GOOSE publishing to 7. The priority of the first re-transmission of the GOOSE is 6, the prior-
ity of the next re-transmission is 5, and then finally 4.
Table 5–1: DYNAMIC VLAN PRIORITY
UR SETTING
7
6
5
4
3
2
1
0
5-22
 
COMMUNICATIONS
GOOSE FUNCTION:
Disabled
GOOSE ID:
MESSAGE
GOOSEOut
DESTINATION MAC:
MESSAGE
000000000000
GOOSE VLAN PRIORITY:
MESSAGE
4
GOOSE VLAN ID:
MESSAGE
0
GOOSE ETYPE APPID:
MESSAGE
0
setting.
RELAY NAME
setting allows the destination Ethernet MAC address to be set. This address must be a multicast
setting indicates the Ethernet priority of GOOSE messages. This allows GOOSE messages to
GOOSE ETYPE APPID
settings are required by IEC 61850.
GOOSE VLAN PRIORITY
ACTUAL PRIORITY
7 to 4
6 to 4
5 to 4
default - fixed at 4
7 to 5
6 to 5
fixed at 5
fixed at 6
B30 Bus Differential System
 
IEC 61850... GSSE/GOOSE...
Range: Enabled, Disabled
Range: 65-character ASCII string
Range: standard MAC address
Range: 0 to 7 in steps of 1
Range: 0 to 4095 in steps of 1
Range: 0 to 16383 in steps of 1
setting allows the selection of a specific application
, and this feature is included only with firmware version
GOOSE VLAN PRIORITY
5 SETTINGS

TRANSMISSION FIXED GOOSE
GOOSE VLAN
setting table. Each subsequent
GE Multilin