Password Security Menu; Local Passwords - GE B30 Instruction Manual

8.1 PASSWORD SECURITY

PATH: SETTINGS PRODUCT SETUP
 SECURITY


PATH: SETTINGS PRODUCT SETUP
 CHANGE LOCAL
 PASSWORDS
Proper password codes are required to enable each access level. A password consists of 1 to 10 numerical characters.
When a
CHANGE COMMAND PASSWORD
interface, the following message sequence is invoked:
1. ENTER NEW PASSWORD: ____________.
2. VERIFY NEW PASSWORD: ____________.
3. NEW PASSWORD HAS BEEN STORED.
To gain write access to a "Restricted" setting, program the
then change the setting, or attempt to change the setting and follow the prompt to enter the programmed password. If the
password is correctly entered, access will be allowed. Accessibility automatically reverts to the "Restricted" level according
8
to the access level timeout setting values.
If an entered password is lost (or forgotten), consult the factory with the corresponding
If the setting and command passwords are identical, then this one password allows access to both commands and
settings.
NOTE
8-2

SECURITY
ACCESS LEVEL:
Restricted
 CHANGE LOCAL
MESSAGE
 PASSWORDS
 ACCESS
MESSAGE
 SUPERVISION
 DUAL PERMISSION
MESSAGE
 SECURITY ACCESS
PASSWORD ACCESS
MESSAGE
EVENTS: Disabled
 
SECURITY CHANGE LOCAL PASSWORDS
CHANGE SETTING
PASSWORD: No
CHANGE COMMAND
MESSAGE
PASSWORD: No
ENCRYPTED SETTING
MESSAGE
PASSWORD: ----------
ENCRYPTED COMMAND
MESSAGE
PASSWORD: ----------
or
CHANGE SETTING PASSWORD
B30 Bus Differential System

8.1.2 PASSWORD SECURITY MENU

Range: Restricted, Command, Setting,
Factory Service (for factory use only)
see page 8–2
see page 8–3
see page 8–4
Range: Disabled, Enabled
Range: No, Yes
Range: No, Yes
Range: 0 to 9999999999
Note: ---------- indicates no password
Range: 0 to 9999999999
Note: ---------- indicates no password
setting is programmed to "Yes" via the front panel
setting in the main security menu to "Setting" and
ACCESS LEVEL
ENCRYPTED PASSWORD
8 SECURITY

8.1.3 LOCAL PASSWORDS

.
GE Multilin