Installation - GE B30 Instruction Manual
Bus differential system, ur series
Hide thumbs
Also See for B30:
- Instruction manual (633 pages) ,
- Communications manual (532 pages) ,
- Technical reference manual (252 pages)
Table of Contents
Advertisement
5 SETTINGS
PATH: SETTINGS
PRODUCT SETUP
INSTALLATION
MESSAGE
To safeguard against the installation of a relay without any entered settings, the unit will not allow signaling of any output
relay until
is set to "Programmed". This setting is defaulted to "Not Programmed" when at the factory. The
RELAY SETTINGS
self-test error message is displayed until the relay is put into the "Programmed" state.
UNIT NOT PROGRAMMED
The
setting allows the user to uniquely identify a relay. This name will appear on generated reports. This name
RELAY NAME
is also used to identify specific devices which are engaged in automatically sending/receiving data over the Ethernet com-
munications channel using the IEC 61850 protocol.
GE Multilin
INSTALLATION
RELAY SETTINGS:
Not Programmed
RELAY NAME:
Relay-1
B30 Bus Differential System
5.2 PRODUCT SETUP
5.2.17 INSTALLATION
Range: Not Programmed, Programmed
Range: up to 20 alphanumeric characters
5
5-63
Advertisement
Table of Contents
