Enjoying The 5.1 Channel Sound With The Optional Amplifier; Recording Between This System And Optional Components - Sony CMT-SE7 Operating Instructions Manual

Enjoying the 5.1 channel
sound with the optional
amplifier
1
Connect the digital optical cable.
See "Hooking up optional components" on
page 79.
2
Connect 6 speakers to an AV amplifier
equipped with a decoder.
For the speaker placement, refer to the
operating instructions supplied with the
connected amplifier.
3
Switch the output to 5.1 channel Dolby
Digital sound or 5.1 channel DTS
sound.
See "Changing the sound (except for
JPEG)" on page 23.
Tip
You cannot use the virtual surround effect of this
system.
Recording between this
system and optional
components
Making a digital recording
from a digital component
The Serial Copy Management System (page 95)
may prevent you from making a digital
recording of certain material. In this case,
connect the component to TAPE IN jacks and
make an analog recording.
In addition, you cannot make a digital recording
of sound encoded by other than PCM mode. Set
optional digital components to PCM output*.
* The digital input is available for PCM 32kHz, 44.1
kHz and 48kHz.
1
Connect the digital optical cable.
See "Hooking up optional components" on
page 79.
2
Start recording manually.
See "Recording on an MD manually"
(page 42).
Note
When Smart Space/Auto Cut is set to on, the recording
pauses if no sound continues for 30 seconds or more
(page 45).
Tips
• You can activate Time Machine Recording (page 43).
• You can adjust the recording level when recording on
an MD (page 46).
Making an analog recording
from an analog component
1
Connect the audio cords.
See "Hooking up optional components" on
page 79.
2
Start recording manually.
See "Recording on an MD manually"
(page 42).
continued
81 GB