Self-Diagnosis Display - Sony CMT-SE7 Operating Instructions Manual

Self-diagnosis display

This system has a Self-diagnosis display
function to let you know if there is a system
malfunction. The display shows a code made up
of three or five letters and a message alternately
to show you the problem. To solve the problem
refer to the following list. If a message appears
in the display, be sure to open the lid of the unit
and confirm the displayed message.
If any problem persists, consult your nearest
Sony dealer.
C11/Protected
The MD is protected against erasure.
cRemove the MD and slide the tab to close the slot
(page 38).
C12/Cannot Copy
The sound you are trying to record is encoded in a
format that this unit cannot record.
cRecord sound output in a format that this unit can
record.
C13/REC Error
Recording could not be performed properly.
cMove the system to a stable place, and start
recording over from the beginning.
The MD is dirty or scratched, or the MD does not
meet the standards.
cReplace the MD and start recording over from the
beginning.
C13/Read Error
The MD deck cannot read the disc information
properly.
cRemove the MD once, then insert it again.
C14/TOC Error
The MD deck cannot read the disc information
properly.
cReplace the MD.
cErase all the recorded contents of the MD using
the All Erase Function (page 55).
GB
88
C41/Cannot Copy
The sound source is a copy of a commercially
available music software.
cThe Serial Copy Management System prevents
making a digital copy (page 95).
The sound you are trying to digitally record is
encoded in a format that this unit is not compatible
with.
cRecord sounds encoded in a format that this unit
can digitally record (see "Before you start
recording" (page 37) and "Recording between this
system and optional components" (page 81)).
C71/Check OPT-IN
If the message disappears shortly after it is
displayed, the interruption was caused by digital
broadcasting signals, and the content of recording is
not affected.
The digital optical cable is disconnected, or the
power of the connected component is turned off
while recording the digital audio from an optional
component connected to the DIGITAL OPTICAL
IN jack.
cConnect the digital optical cable, or turn on the
power of the connected component.
E0001/MEMORY NG
The component has internal problem.
cConsult your nearest Sony dealer.
E0101/LASER NG
There is a problem with the laser pickup.
cThe laser pickup may be damaged. Consult your
nearest Sony dealer.
E0201/LOADING NG
There is a problem with loading.
cConsult your nearest Sony dealer.