Enjoying The 5.1 Channel Sound With The Optional Amplifier; Recording On A Connected Component - Sony CMT-WS2D Operating Instructions Manual

Enjoying the 5.1 channel
sound with the optional
amplifier
1
Connect a digital optical cord.
See "Hooking up optional components" on
page 55.
2
Connect 6 speakers to an AV amplifier
equipped with a decoder.
For the speaker placement, refer to the
operating instructions supplied with the
connected amplifier.
3
Switch the output to 5.1 channel Dolby
Digital sound or 5.1 channel DTS
sound.
See "Changing the sound" on page 30.
Note
If you press AUDIO, SOUND FIELD or the buttons
related to karaoke mode, or if you connect or
disconnect headphones, the sound cuts off for a
moment.
Tip
You cannot use the surround effect of this system.
Recording on a connected
component
Making an analog recording
1
Connect audio cords.
See "Hooking up optional components" on
page 55.
2
Start recording.
Refer to the operating instructions provided
with the connected component.
Making an analog recording
from a VIDEO CD to a video
tape
1
Connect optional audio cords from the
VIDEO/SAT OUT L/R (audio) jacks and
the supplied video cable from the
VIDEO OUT jack to your VCR.
2
Start recording.
Refer to the operating instructions provided
with the connected component.
Note
If the picture has disturbance or there is noise in the
audio when a TV, a video deck and this system are all
connected at the same time, disconnect one of them.
GB
57