Intermittent Wiper System; Windshield Washer Operation - Chrysler 200 2017 Owner's Manual

136 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
NOTE: If snow packing occurs that obstructs the normal
operation of the windshield wipers the following message
will appear in the instrument cluster display: Front Wipers
Blocked Cycle Switch or Clean the Windshield . It is
important to remove the snow accumulation to allow the
wipers to function normally and to maintain good visibil-
ity of the road.
CAUTION!
Always remove any buildup of snow that prevents the
windshield wiper blades from returning to the park
position. If the windshield wiper switch is turned off,
and the blades cannot return to the park position,
damage to the wiper motor may occur.

Intermittent Wiper System

Use one of the four intermittent wiper settings when
weather conditions make a single wiping cycle, with a
variable delay between cycles, desirable. At driving speeds
above 10 mph (16 km/h), the delay can be regulated from
a maximum of approximately 18 seconds between cycles
(first detent), to a cycle every one second (fourth detent).
Intermittent Wiper Operation
NOTE: If the vehicle is moving less than 10 mph
(16 km/h), delay times will be doubled.

Windshield Washer Operation

To use the washer, pull the lever rearward toward you and
hold while spray is desired. If the lever is pulled while in
the intermittent setting, the wipers will turn on and operate
for several wipe cycles after the lever is released, and then
resume the intermittent interval previously selected.