Table of Contents
Advertisement
G E T T I N G S T A R T E D
3. Push the ENGINE START/STOP button a third time to return the ignition to the OFF
position.
NOTE:
If the ignition is left in the ACC or ON/RUN
(engine not running) position and the transmis-
sion is in PARK, the system will automatically
time out after 30 minutes of inactivity, and the
ignition is returned to the OFF position.
VEHICLE SECURITY ALARM
The Vehicle Security Alarm monitors the vehicle doors for unauthorized entry and the ignition for
unauthorized operation. While the Vehicle Security Alarm is armed, interior switches for door
locks and decklid release are disabled. If something triggers the alarm, the Vehicle Security Alarm
will provide the following audible and visible signals: the horn will pulse, the park lamps and/or
turn signals will flash, and the Vehicle Security Light in the instrument cluster will flash.
To Arm
• Keyless Enter-N-Go button installed: Push the Keyless Enter-N-Go START/STOP button
until the Electronic Vehicle Information Center (EVIC) indicates that the vehicle ignition is
"OFF." Push the power door LOCK switch while the door is open, push the Key Fob LOCK
button, or with one of the Key Fobs located outside the vehicle, and within 5 ft (1.5 m) of the
driver's and passenger front door handles, push the Keyless Enter-N-Go LOCK button
located on the door handle.
• Keyless Enter-N-Go button not installed: Turn the ignition switch to the "OFF" position.
Push the power door lock switch while the door is open, push the Key Fob LOCK button with
one of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and
passenger front door handles.
NOTE:
After pushing the Keyless Enter-N-Go LOCK button, you must wait two seconds before you can
lock or unlock the vehicle via the door handle.
To Disarm
• Keyless Enter-N-Go button installed: Push the Key Fob UNLOCK button or with one of
the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and passenger
front door handles, grab the Keyless Enter-N-Go door handle and enter the vehicle, then push
the Keyless Enter-N-Go START/STOP button (requires at least one valid Key Fob in the
vehicle).
• Keyless Enter-N-Go button not installed: Push the Key Fob UNLOCK button or with one
of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and passenger
front door handles, grab the Keyless Enter-N-Go door handle and enter the vehicle, then turn
the ignition to the ON/RUN position.
14
Ignition Positions
Advertisement
Table of Contents
