Single Point Calibration; Setting Mode & Description Of Parameter Values - Jadever 1.5K User Manual

JWL-6K, 1/3 of full load is 2 kg)
4) Wait till appears, put weights
JWL-6K, 2/3 of full load is 4 kg)
5) Wait till appears, put weights of full load on the weighing pan (E.g. for JWL appears, put weights of full load on the weighing pan (E.g. for JWL-6K, full appears, put weights of full load on the weighing pan (E.g. for JWL
load is 6kg)
6) The calibration procedure ends up with a symbol The calibration procedure ends up with a symbol of "
7) Remove all the weights, and then press key Remove all the weights, and then press key

Single Point Calibration

1 ） Press and hold key
release the
TARE
2 ） Press key to enter the zero point calibration to enter the zero point
3 ） Wait till the
PRINT/HI
shift leftwards, key
M-
key to decrease setting value.
4 ） Put the corresponding weights on the weighing pan and press key Put the corresponding weights on the weighing pan and press key
procedure starts.
5 ） A few seconds later, the calibration procedure is completed with
the screen. Remove all the weights and press key the screen. Remove all the weights and press key
mode.
7. Setting Mode & Description of Parameter Setting Mode & Description of Parameter Values
MODE
1) Long press key
reverts to available setting items .There reverts to available setting items .There are 12 available setting items (p00-p11) ,indicated
Auxiliary display in the Lower Left corner Auxiliary display in the Lower Left corner .
M+
2) Press key or key
weights of 2/3 of full load on the weighing
M-
while powering on the scale. The screen displays while powering on the scale. The screen displays while powering on the scale. The screen displays
" appears (with the right " appears (with the right-most digit blinking), press key
to shift rightwards, key to shift rightwards, key
value.
the calibration procedure is completed with
for 3 seconds for 3 seconds,
M-
to step through all the available setting items ,and release on the to step through all the available setting items ,and release on to step through all the available setting items ,and release on
TARE
to return to weighing mode.
most digit blinking), press key
M+
to increase setting values and to increase setting values and
TARE
to return to normal weighing to return to normal weighing
display momentarily before the display display momentarily before the display
Vetek Weighing AB Vetek
weighing pan (E.g. for
mode.
", then
UNIT/LO
N/G N/G
, the calibration
" displayed on " displayed
p11) ,indicated by
to