Table of Contents
Advertisement
Modifications
If the device is changed or modified without the express approval of Olicom A/S the user may void his
or her authority to operate the equipment.
Safety Notices
Danger: To avoid shock hazard, do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguring of the CrossFire 8720 Fast Ethernet Layer 3 Switch during an electrical
storm.
Danger: To avoid the possibility of electrical shock, switch power off and unplug the power cord from
the outlet before detaching the power cord from the CrossFire 8720 Fast Ethernet Layer 3 Switch.
Danger: Do not open the CrossFire 8720 Fast Ethernet Layer 3 Switch. Dangerous voltages inside.
Danger: To avoid shock hazard the power cord must be connected to a properly wired and grounded
receptacle. Any equipment to which the CrossFire 8720 Fast Ethernet Layer 3 Switch will be attached
must also be connected to properly wired and grounded receptacles.
Caution: Observe the following power cable considerations before you begin installation of the
CrossFire 8720 Fast Ethernet Layer 3 Switch.
1.
The socket outlet must be installed near the equipment and must be easily accessible.
2.
To prevent electrical shock, the power cord set used must comply with national regulations.
2a.
The female receptacle of the cord must meet CEE-22 requirements.
2b.
The cord must be UL listed, CSA labelled, and consist of three conductors with a maximum
of 15 feet in length.
Type SVT or SJT cord sets must be used for units which stand on a desk or table. Type SJT
cord sets must be used for units which stand on floor.
2c.
The male plug for units operating at 115 VAC must consist of a parallel blade, grounding
type attachment plug rated 15 A, 125 VAC.
The male plug for units operating at 230 VAC must consist of a tandem blade, grounding
type attachment plug rated 15 A, 250 VAC.
The male plug for units operating at 230 VAC (outside of the United States and Canada) must
consist of a grounding type attachment plug rated 15 A, 250 VAC and have the appropriate
safety approvals for the country in which the equipment will be installed.
Caution: Support the while you are installing the unit to avoid dropping it on the floor or any equipment
beneath it in the rack. The CrossFire 8720 Fast Ethernet Layer 3 Switch unit weighs approximately 8.8
kg (19.4 lbs).
Warning: All RJ45 connectors must only be connected to safety extra low voltage (SELV) circuits like
local area networking (LAN).
CrossFire 8720 Fast Ethernet Layer 3 Switch, v. 1.00.02, P/N: 710001800
iii
Advertisement
Table of Contents
