Table of Contents
Advertisement
4
1.4 Default Settings for the Switch
The factory switch settings should be sufficient for layer-2 connectivity in most
configurations. If you are going to employ the switch's layer 3 functionality,
however, you must configure IP subnets and possibly RIP routing before you start
using the switch.
The most important default settings are listed in table 5:
IP Management Access
IP configuration
SNMP communities
Authentication traps
Trap receivers
Console / Serial Link Access
Serial link settings
Enable inband Telnet to console
Enable web-browser interface access
Enable console access
Console call-back
Management access passwords
CrossFire 8720 Fast Ethernet Layer 3 Switch, v. 1.00.02, P/N: 710001800
Feature
Default Value
IP address: 192.0.2.1
IP mask: 255.255.255.0
Configured on default subnet (VLAN)
Public: RO
Private: RW
Addresses unrestricted
On
None
Speed 9600 baud rate
RTS/CTS handshake: On
No modem initialization string
Enabled
Enabled
Enabled
Off
None
Introduction
Advertisement
Table of Contents
