Turbo Ring Dip Switch - Weidmuller IE-SW-VL08M Series User Manual

IE-SW-VL08M Series User's Manual
Setting
1st Time Server
IP/Name
2nd Time Server
IP/Name
Time Server Query Period
Setting
Query Period

Turbo Ring DIP Switch

The Turbo Ring DIP Switch page allows users to disable the four DIP switches located on the
switch's outer casing. When enabled, the DIP switches can be used to configure basic settings for
either the "Turbo Ring" protocol or "Turbo Ring V2" protocol. A complete description of the
settings is given below.
NOTE
The "Turbo Ring" protocol (recovery time < 300 ms) provides better network reliability and faster
recovery time for redundant ring topologies. The "Turbo Ring V2" protocol (recovery time < 20
ms), supports additional redundant ring architectures.
In this manual, we use the terminology "Turbo Ring" ring and "Turbo Ring V2" ring to
differentiate between rings configured for one or the other of these protocols.
For a detailed description of "Turbo Ring" and "Turbo Ring V2," please refer to the Using
Communication Redundancy section later in this chapter.
How to Enable or Disable the Turbo Ring DIP Switches
Enable / Disable the Turbo Ring DIP Switch
Description
IP or Domain address (e.g., 192.168.1.1 or
time.nist.gov)
The device will try to locate the 2nd NTP
Server if the connection to the 1
failed.
Description
This parameter determines how frequently the
time is updated from the NTP server.
3-10
Featured Functions
Factory Default
None
st
NTP server
Factory Default
600 seconds