Weidmuller IE-SW-VL08M Series User Manual page 46

IE-SW-VL08M Series User's Manual
Enable Ring Coupling
Setting
Enable
Disable
Coupling Mode
Setting
Dual Homing
Ring Coupling
(backup)
Ring Coupling
(primary)
Primary/Backup Port
Setting
Primary Port
Backup Port
NOTE
The Turbo Ring DIP Switches located on the
IE-SW-VL08M's outer casing can be used to configure
the devices's Turbo Ring protocols. (For details on how
to do this, refer to "Configuring Basic Settings—Turbo
Ring DIP Switch" section in this manual.)
If you use the web interface, console interface, or
Telnet interface to enable the Turbo Ring DIP
Switches, and then set DIP Switch 4 on the switch's
outer casing to the "ON" position, you will not be able
to use the web interface, console interface, or Telnet
interface to change the status of the DIP Switch. In this
case, the Communication Redundancy settings will
be "grayed out" in the web browser as shown in the
following figure:
Description
Select this switch as Coupler
Do not select this switch as Coupler
Description
Select this item to change to the Dual
Homing configuration page
Select this item to change to the Ring
Coupling (backup) configuration page
Select this item to change to the Ring
Coupling (primary) configuration page
Description
Select any port of the switch to be the
primary port.
Select any port of the switch to be the
backup port.
3-30
Featured Functions
Factory Default
Not checked
Factory Default
Primary Port: Port 5
Backup Port: Port 6
Primary Port: Port 2
Backup Port: Port 3
Port 5
Port 2
Port 5
Port 2
Factory Default
Port 2
Port 5
Port 3
Port 6