Configuring Virtual Lan - Weidmuller IE-SW-VL08M Series User Manual

IE-SW-VL08M Series User's Manual
Packets from device H will travel through "Trunk Port 3" with PVID 3. Switch A will recognize
its VLAN and pass it to port 2, but will not remove tags received successfully by device D.
Packets from device E will travel through "Trunk Port 3" with tagged VID 4. Switch B will
recognize its VLAN, pass it to port 7, and then remove tags received successfully by device I.
Packets from device I will travel through "Trunk Port 3" with tagged VID 4. Switch A will
recognize its VLAN and pass it to port 2, but will not remove tags received successfully by device
E.

Configuring Virtual LAN

VLAN Settings
To configure the IE-SW-VL08M's 802.1Q VLAN, use the VLAN Setting page to configure the
ports.
VLAN Mode
Setting
802.1Q VLAN
Port-based VLAN Set VLAN mode to Port-based VLAN
Management VLAN ID
Setting
VLAN ID ranges
from 1 to 4094
Enable GVRP
Setting
Enable/Disable
Port Type
Setting
Access
Trunk
Description
Set VLAN mode to 802.1Q VLAN
Description
Set the management VLAN of this Ethernet Switch
Description
Select the option to enable/disable the GVRP function. Enable
Description
This port type is used to connect single devices without
tags.
Select "Trunk" port type to connect another 802.1Q
VLAN aware switch or another LAN that combines
3-50
Featured Functions
Factory Default
802.1Q VLAN
Factory Default
1
Factory Default
Factory Default
Access