Verify Configuration - Emerson Rosemount 8800D Series Quick Start Manual

Quick Start Guide
5. Verify the cover cannot be removed.

2.5 Verify configuration

Before operating the Rosemount 8800D in an installation, you should review the
configuration data to ensure it reflects the current application. In most cases, all
of these variables are pre-configured at the factory. Configuration may be
required if your 8800D is not configured or if the configuration variables need
revision.
Rosemount recommends the following variables are reviewed before startup:
Table 1. Configuration Variables to Consider
HART configuration
• Tag
• Transmitter Mode
• Process Fluid
• Reference K-Factor
• Flange Type
• Mating Pipe ID
• PV Units
• PV Damping
• Process Temperature Damping
• Fixed Process Temperature
• Auto Adjust Filter
• LCD Display Configuration (for units with a
display only)
• Density Ratio (for Standard or Normal flow units
only)
• Process Density and Density Units (for mass flow
units only)
• Variable Mapping
• Range Values
• Pulse Output Configuration (for units with a pulse
output only)
16
F fieldbus configuration
OUNDATION
• Tag
• Transmitter Mode
• Process Fluid
• Reference K-Factor
• Flange Type
• Mating Pipe ID
• PV Units (configured in the AI block)
• Flow Damping
• Process Temperature Damping
• Fixed Process Temperature
• Auto Adjust Filter
• LCD Display Configuration (for units with a display
only)
• Density Ratio (for Standard or Normal flow units
only)
• Process Density and Density Units (for mass flow
units only)
April 2016