Emerson Rosemount 8800D Series Quick Start Manual page 21

April 2016
4.4 European Pressure Equipment Directive (PED)
Rosemount 8800D Vortex Flowmeter Line Size 40 mm to
300 mm
Certificate Number 4741-2014-CE-HOU-DNV
0575 or 0496
Module H Conformity Assessment
Mandatory CE-marking for flowmeters in accordance with Article 15 of the PED
can be found on the flowtube body.
Flowmeter categories I – III use module H for conformity assessment procedures.
Rosemount 8800D Vortex Flowmeter Line Size 15 mm and 25 mm
Sound Engineering Practice (SEP)
Flowmeters that are SEP are outside the scope of PED and cannot be marked for
compliance with PED.
5.0 Hazardous Location Certifications
5.1 North American Certifications
Factory Mutual (FM)
E5 Explosion proof-Intrinsically Safe for Class I, Division 1, Groups B, C, and D;
Dust-ignition proof for Class II/III, Division 1, Groups E, F, and G;
Temperature Code T6 (-50 °C  Ta  70 °C)
Factory Sealed
Enclosure Type 4X, IP66
I5 Intrinsically safe for use in Class I, II, III Division 1, Groups A, B, C, D, E, F, and G;
Non-incendive for Class I, Division 2, Groups A, B, C, and D
NIFW (Non-incendive Field Wiring) when installed per Rosemount Drawing
08800-0116
Temperature Code T4 (-50 °C  Ta  70 °C) 4-20 mA HART
Temperature Code T4 (-50 °C  Ta  60 °C) Fieldbus
Enclosure Type 4X, IP66
IE FISCO for Class I, II, III, Division 1, Groups A, B, C, D, E, F and G;
FNICO for Class I Division 2, Groups A, B, C, and D
when installed per Rosemount control drawing 08800-0116
Temperature Code T4 (-50 °C  Ta  60 °C)
Enclosure Type 4X, IP66
Combined Factory Mutual (FM) Certifications
K5 E5 and I5 Combination
Special Conditions for Safe Use (X):
1. When fitted with 90V transient suppressors (T1 Option), the equipment is not capable
of passing the 500V insulation test. This must be taken into account upon installation.
2. The Model 8800D Vortex Flowmeter when ordered with aluminum electronics housing
is considered to constitute a potential risk of ignition by impact or friction. Care should
be taken into account during installation and use to prevent impact or friction.
Quick Start Guide
21