Set Jumpers - Emerson Rosemount 8800D Series Quick Start Manual

Quick Start Guide
Caution
Do not pull the housing more than 1.5-in. (40 mm) from the top of the support tube until the
sensor cable is disconnected. Damage to the sensor may occur if this sensor cable is stressed.
3. Unscrew the sensor cable from the housing with a
4. Rotate the housing to the desired orientation.
5. Hold in this orientation while screwing sensor cable onto base of the housing.
Caution
Do not rotate the housing while the sensor cable is attached to the base of the housing. This will
stress the cable and may damage the sensor.
6. Place the electronics housing into the top of the support tube.
7. Use a /
5
32
counter-clockwise (outward) to engage the support tube.

2.3 Set jumpers

Adjust jumpers to desired settings.
®
HART
If alarm and security jumpers are not installed, the flowmeter will operate
normally with the default alarm condition alarm "HI" and the security "OFF".
Figure 10. HART Jumpers and LCD Display
10
-in. hex wrench to turn the three housing rotation screws
/ -in. open end wrench.
5
16
LO
HI
ALARM
SECURITY
ON
OFF
April 2016