Qos Wrr Weight - HP HSR6800 Command Reference Manual

sp: Specifies strict priority (SP) queuing.
Usage guidelines
This command is available only on a WRR-enabled interface. Queues in the SP group are scheduled with
SP. The SP group has strict higher scheduling priority than the WRR groups.
Settings in Ethernet interface view take effect on the current interface only. Settings in port group view
take effect on all the ports in the port group.
Examples
# Enable WRR queuing on GigabitEthernet 1/0/1, and assign queue 0 to the SP group.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr
[Sysname-GigabitEthernet1/0/1] qos wrr 0 group sp
Related commands
display qos wrr interface
•
qos wrr
•

qos wrr weight

Use qos wrr weight to assign a queue to a WRR group, with a certain scheduling weight, on an interface
that performs packet-based WRR queuing.
Use undo qos wrr weight to restore the default WRR queuing settings of a queue on an interface.
Syntax
qos wrr queue-id group 1 weight schedule-value
undo qos wrr queue-id group 1 weight
Views
Interface view, port group view
Default command level
2: System level
Parameters
queue-id: Queue ID in the range of 0 to 7.
1: Specifies WRR group 1.
weight schedule-value: Specifies a scheduling weight for the specified queue in packet-based WRR
queuing. The value range for the schedule-value argument is 1 to 8.
values for queues.
Table 37 Default weight values for queues
Queue
0
1
2
3
Weight
1
2
3
4
118
Table 37 shows the default weight