Table of Contents
Advertisement
3.
Configure SP queuing.
4.
Display SP queuing
configuration.
Configuration example
1.
Network requirements
Configure GigabitEthernet 1/0/1 to use SP queuing.
2.
Configuration procedure
# Enter system view
<Sysname> system-view
# Configure GigabitEthernet1/0/1 to use SP queuing.
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos sp
Configure group-based WRR queuing
When a WRR queue is configured on an interface, WRR queuing is enabled on the interface, and
other queues on the interface use the default WRR scheduling value and are assigned to the default
WRR priority group.
Configuration procedure
Step
1.
Enter system view.
2.
Enter interface view or
port group view.
3.
Enable WRR queuing.
4.
Configure a basic
WRR queue.
5.
Display WRR queuing
configuration
information on
interfaces.
1.
Configuring group-based WRR queuing
Step
1.
Enter system view.
qos sp
display qos sp interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Command
system-view
•
Enter interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
qos wrr
qos wrr queue-id weight
schedule-value
display qos wrr interface
[ interface-type
interface-number ] [ | { begin |
exclude | include }
regular-expression ]
Command
system-view
70
By default, basic SP queuing is used.
Only Layer 2 Ethernet interfaces
support configuring SP queuing.
Optional.
Available in any view.
Remarks
N/A
Settings in interface view take effect on the
current interface. Settings in port group
view take effect on all ports in the port
group.
WRR queuing is only applicable to Layer 2
interfaces.
By default, an interface uses SP queuing.
N/A
Optional.
Available in any view.
Remarks
N/A
Advertisement
Table of Contents
