Packet Resequencing Commands; Qos Resequencing - HP HSR6800 Command Reference Manual

Examples
# Limit the rate of outgoing packets on GigabitEthernet 1/0/1, with CIR 20 kbps, CBS 2000 bytes, and
EBS 0.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos lr outbound cir 20 cbs 2000 ebs 0

Packet resequencing commands

qos resequencing

Use qos resequencing to enable packet resequencing on an interface.
Use undo qos resequencing to disable packet resequencing on an interface.
Syntax
qos resequencing
undo qos resequencing
Default
The packet resequencing function is disabled.
Views
Interface view
Default command level
2: System level
Usage guidelines
When the network traffic is out of sequence, some systems that cannot resequence packets, such as a
video conferencing terminal, might encounter mosaic. The packet resequencing function can alleviate
this problem.
After you enable or disable packet resequencing, to make the configuration take effect, you must
re-enable the interface by using the shutdown and undo shutdown command sequence.
Examples
# Enable packet resequencing on interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos resequencing
[Sysname-GigabitEthernet1/0/1] shutdown
[Sysname-GigabitEthernet1/0/1] undo shutdown
84