Redirect - HP HSR6800 Command Reference Manual

cbs cbs-time: Sets the CBS in the specified time in ms. The default cbs-time is 500. The actual CBS value
is cbs-time × the actual CIR value.
ebs ebs-time: Sets the EBS in the specified time in ms. The default ebs-time is 0 ms. The actual EBS value
is ebs-time × the actual CIR value.
Usage guidelines
A QoS policy that references a behavior configured with GTS can be applied to only the outbound
direction of an interface or PVC.
A QoS policy that references a behavior configured with GTS overwrites the qos gts command on the
interface or PVC, if both configured.
If this command is configured for the same traffic behavior multiple times, the most recent configuration
takes effect.
GTS for software forwarding does not support IPv6.
Examples
# Configure a GTS action in percentage in the traffic behavior database. The GTS parameters are as
follows: CIR is 50 and CBS is 2000.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] gts percent cir 50 cbs 200
Related commands
• classifier behavior
gts
•
• qos policy
traffic behavior
•

redirect

Use redirect to configure a traffic redirecting action in the traffic behavior.
Use undo redirect to delete the traffic redirecting action.
Syntax
redirect { cpu | interface interface-type interface-number | next-hop { ipv4-add1 [ ipv4-add2 ] |
ipv6-add1 [ ipv6-add2 ] } }
undo redirect { cpu | interface interface-type interface-number | next-hop }
Views
Traffic behavior view
Default command level
2: System level
Parameters
cpu: Redirects traffic to the CPU.
interface: Redirects traffic to an interface.
interface-type interface-number: Specifies an interface by its type and number. To redirect traffic to a
tunnel, set the interface type to tunnel. To redirect traffic to a Layer 2 aggregate interface, set the
48