HP HSR6800 Command Reference Manual page 31

Parameters Function
{ ack ack-value
| fin fin-value |
Specifies one or more
psh psh-value |
TCP flags, including
rst rst-value |
ACK, FIN, PSH, RST,
syn syn-value |
SYN, and URG.
urg urg-value }
*
Specifies the flags for
indicating the
established
established status of a
TCP connection.
If the protocol argument takes icmpv6 (58), set the parameters shown in
Table 12 ICMPv6-specific parameters for IPv6 advanced ACL rules
Parameters
icmp6-type { icmp6-type
icmp6-code |
icmp6-message }
Table 13 ICMPv6 message names supported in IPv6 advanced ACL rules
ICMPv6 message name
echo-reply
echo-request
err-Header-field
frag-time-exceeded
hop-limit-exceeded
host-admin-prohib
host-unreachable
neighbor-advertisement
neighbor-solicitation
network-unreachable
packet-too-big
port-unreachable
redirect
router-advertisement
router-solicitation
unknown-ipv6-opt
unknown-next-hdr
Description
Parameters specific to TCP.
The value for each argument can be 0 (flag bit not set) or 1 (flag bit
set).
Parameter specific to TCP.
The rule matches TCP connection packets with the ACK or RST flag
bit set.
Function
Specifies the ICMPv6
message type and
code.
ICMPv6 message type
129
128
4
3
3
1
1
136
135
1
2
1
137
134
133
4
4
25
Description
The icmp6-type argument is in the range of 0 to 255.
The icmp6-code argument is in the range of 0 to 255.
The icmp6-message argument specifies a message name.
Supported ICMP message names and their corresponding
type and code values are listed in
Table 12.
Table 13.
ICMPv6 message code
0
0
0
1
0
1
3
0
0
0
0
4
0
0
0
2
1