Installing The Software - 123ignition 123-TUNE-4-R-V User Manual

INSTALLING THE SOFTWARE

GB
Important : Do not connect the 123\TUNE, until you have installed the software !
Go to the site www.123ignition.nl and download the latest version of the 123\TUNE-software. This
software-package is designed for Windows XP and onwards.
Run the software, and you will see an electronic dashboard. In the top-center you will see two grey tabs,
with 'DASHBOARD' and 'SETTINGS'.
By clicking 'SETTINGS' you will see the page, where you can edit your centrifugal and vacuum advance-
curves, and where you can 'STORE' them into your 123\TUNE.
Click 'DASHBOARD' again, and you will see the electronic dashboard again. Note the red dot in the
bottom-left corner. This indicates that there is presently no connection.
Now connect your 123\TUNE ( use a shielded USB-cable ONLY ; Belkin is a good brand ), and you will
see this dot become green, accompanied by an audible signal.
For programming the 123\TUNE will be powered from the USB-port in your computer.
Important keys to memorize :
alt-F4 ➔ closes the program
F8
➔ switches the RPM-stopwatch on and off.
F11 ➔ switches to and from "Full-Screen" ( which is nice for the dashboard-feature )