Installing/Removing An Interface Card; Installing An Interface Card - HP 5500 HI Series Installation Manual

Figure 39 Connecting the PSR720-56A

Installing/removing an interface card

This section uses the LSPM2SP2P (JD368B) interface card as an example to describe the procedures of
installing and removing an interface card.
For the interface cards available for the switch series, see

Installing an interface card

IMPORTANT:
On the 5500-24G-4SFP HI (2 slots), 5500-24G-SFP HI (2 slots), 5500-24G-SFP HI TAA (2 slots),
5500-24G-PoE+-4SFP HI (2 slots), and 5500-24G-PoE+-4SFP HI TAA (2 slots) switches, you can install
the LSP5GP8P0 (JG314A) and LSP5GT8P (JG313A) cards only in SLOT1.
To install an interface card:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded.
Loosen the mounting screws on the filler panel over the interface card slot with a Phillips
2.
screwdriver and remove the filler panel.
Put away the removed filler panel for future use.
"Interface
28
cards."