Table of Contents
Advertisement
Eaton 93PS UPS 8–40 kW
5
UPS system installation
The operator has to supply the wiring to connect the UPS to the local power
source. The installation of the UPS must be made by a locally qualified
electrician. The electrical installation procedure is described in the following
section. The installation inspection and the initial start-up of the UPS and
installing an extra battery cabinet must be carried out by an authorized Eaton
Customer Service Engineer or by other qualified service personnel authorized
by Eaton.
To avoid physical injury or death, or damage to the UPS or the load
equipment, follow these instructions during the UPS system installation.
In case of condensed moisture inside the UPS cabinet, dry the cabinet with a
blower before starting up the system.
5.1
Power and control wiring are routed through the rear of the cabinet with
connections made to easily accessible terminals, see Figure
To install and connect the power cabling of the external battery to the UPS, see
5.2
Section
©
Eaton Corporation plc 2016. All rights reserved.
Steps to install the UPS
.
CAUTION
CAUTION
Revision: 003
Document ID: P-164000493
User's and installation guide
12
13
and Figure
49 (104)
.
Advertisement
Table of Contents
