Unpacking And Unloading The Ups - Eaton 93PS-8(20)-20(-C) User And Installation Manual

Eaton 93PS UPS 8–40 kW
Source protection for the AC input to bypass must suit the characteristics of the
load and take into account effects such as inrush or starting current.
Bypass input and output overcurrent protection and bypass, output and
accessory disconnect switches must be provided by the user.
4.4
Before you start to unpack and unload the UPS, check the TipNTell / DropNTell
indicator on the package surface (see step 2 below). If the equipment has been
correctly transported in the upright position, the indicator should be intact. If the
indicator arrow has turned all blue, contact the appropriate parties to report
inappropriate transportation.
The UPS cabinet is heavy. If the unpacking instructions are not closely
followed, the cabinet may tip over and cause serious injury.
Do not tilt the UPS cabinet more than 10 degrees from the vertical or the
cabinet may tip over.
For transportation purposes, the UPS cabinet is bolted onto a wooden pallet. To
remove the pallet, perform the following procedure:
1. Before you unload the cabinet
from the pallet, use a forklift or
other material handling
equipment to move the cabinet
to the installation area. Insert
the forks of the forklift between
the skids on the bottom of the
unit.
©
Eaton Corporation plc 2016. All rights reserved.

Unpacking and unloading the UPS

WARNING
Revision: 003 Document ID: P-164000493
User's and installation guide
45 (104)