Table of Contents
Advertisement
Eaton 93PS UPS 8–40 kW
7
UPS operating instructions
This section describes how to operate the UPS.
Before you operate the UPS, make sure that all the installation tasks are
completed and a preliminary startup has been performed by authorized
service personnel. The preliminary startup verifies all the electrical
interconnections to make sure that the installation was successful and the
system operates properly.
Before you operate any of the controls, read these instructions and have a
thorough understanding of the UPS operation.
The UPS is configured to operate with one of the following nominal voltages:
380, 400, or 415 VAC. Before you start to operate the UPS, confirm the UPS
nominal voltage and frequency from the display by selecting Settings >
Information. If the UPS need to be operated with another voltage or
frequency, contact your closest Eaton office or Eaton authorized partner.
Note: The UPS is not a measuring device. All the displayed measurements
are approximate values only.
7.1
7.1.1
The control panel, located on the UPS front door, contains a color touch screen
display. It is used to display the status of the UPS system and to control the
operation of the UPS.
©
Eaton Corporation plc 2016. All rights reserved.
UPS controls and indicators
Control panel
CAUTION
Revision: 003
Document ID: P-164000493
User's and installation guide
73 (104)
Advertisement
Table of Contents
